Garmin Software Version 0321.23 Manuál Strana 232

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 266
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 231
Page 7-24 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
7.6.4 Static Port Vertical Speed (Rate of Climb) Test
1. Command ADTS to change the altitude at the rates shown in the table below.
2. Wait for ADTS to report that target rates have been achieved.
3. Verify that the Rate of Climb reported by the Vertical Speed field on the PFD is within the tolerances
specified in the table below:
Table 7-4. Vertical Speed Test Tolerances
Vertical Speed, feet/minute Allowed tolerance, ±feet/minute
2000 100
1000 50
500 45
200 45
0 45
-200 45
-500 45
-1000 50
-2000 100
7.6.5 OAT Probe Check
Check the outside air temperature (OAT) measurement shown on the PFD to ensure it reads ambient
temperature, within +/- 2.0 degrees (reference a second thermometer for ambient temperature
comparison).
If no other service is to be performed, continue to the return-to-service checks in Section 8.
Zobrazit stránku 231
1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 265 266

Komentáře k této Příručce

Žádné komentáře