Garmin Software Version 0321.23 Manuál Strana 195

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 266
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 194
G1000 System Maintenance Manual – Diamond DA40/40F Page 6-1
190-00545-01 Revision G
6 G1000 Equipment Removal & Replacement
This section describes how to remove and replace G1000 equipment in the Diamond DA 40. After
removal and replacement, LRUs must be configured and tested as described in Section 7.
CAUTION
When removing and/or replacing any G1000 component, always ensure that aircraft
power is off. Unplug any auxiliary power supplies. Before performing maintenance, it is
required that the technician verify the LRU software part number and version number
matches the software configuration listed in the appropriate General Arrangement
drawing.
To check an LRU software part number and/or version:
1. Start the G1000 system in configuration mode as described in Section 3.3.
Figure 6-1. (SW v0321.19 or earlier)
System Status Page (Configuration Mode)
Zobrazit stránku 194
1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 265 266

Komentáře k této Příručce

Žádné komentáře