Garmin Software Version 0321.23 Manuál Strana 203

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 266
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 202
G1000 System Maintenance Manual – Diamond DA40/40F Page 6-9
190-00545-01 Revision G
Figure 6-3. Configuration Module Installation
Table 6-2. Configuration Module Kit – 011-00979-00
Item Description Qty Needed Garmin Part Number
011-00979-00
Kit
011-00979-03
Kit
1
Configuration Module PCB
Board Assembly
w/EEPROM & Temp
Sensor
1
012-00605-00 011-02178-00
2 Spacer, Config Module 1 213-00043-00 N/A
3
Cable, 4-Conductor
Harness
1
325-00122-00
4 Pins, #22 AWG (HD) 5 336-00021-00
Removal:
NOTE
Use ESD protection when handling the configuration module.
1. Disconnect connector from LRU.
2. Remove 2 screws (8) from cover (7) and remove cover.
3. Unplug connector from configuration module (1).
4. Remove configuration module.
Replacement:
1. Inspect connector for damaged pins (4).
2. Place configuration module (1) in position.
3. Insert connector into configuration module (1).
4. Assembly of the connector is the reverse of disassembly.
5. Continue to Section 6.12.1.
Zobrazit stránku 202
1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 265 266

Komentáře k této Příručce

Žádné komentáře