Garmin Software Version 0534.21 Uživatelská příručka Strana 104

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 134
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 103
Garmin G1000 Cockpit Reference Guide for the Cessna Corvalis/Corvalis TT
190-00567-05 Rev. A
88
Annunciations & Alerts
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
GIA 63W MESSAGE ADVISORIES (CONT.)
Message Comments
MANIFEST
– COM1 software
mismatch, communication halted.
COM1 and/or COM2 software mismatch. The
system should be serviced.
MANIFEST
– COM2 software
mismatch, communication halted.
MANIFEST
– NAV1 software
mismatch, communication halted.
NAV1 and/or NAV2 software mismatch. The
system should be serviced.
MANIFEST
– NAV2 software
mismatch, communication halted.
COM1 TEMP
– COM1 over temp.
Reducing transmitter power.
The system has detected an over temperature
condition in COM1 and/or COM2. The transmitter
is operating at reduced power. If the problem
persists, the system should be serviced.
COM2 TEMP
– COM2 over temp.
Reducing transmitter power.
COM1 SERVICE
– COM1 needs
service. Return unit for repair.
The system has detected a failure in COM1 and/
or COM2. COM1 and/or COM2 may still be
usable. The system should be serviced when
possible.
COM2 SERVICE
– COM2 needs
service. Return unit for repair.
COM1 PTT
– COM1 push-to-talk
key is stuck.
The COM1 and/or COM2 external push-to-talk
switch is stuck in the enable (or “pressed”)
position. Press the PTT switch again to cycle its
operation. If the problem persists, the system
should be serviced.
COM2 PTT
– COM2 push-to-talk
key is stuck.
COM1 RMT XFR
– COM1 remote
transfer key is stuck.
The COM1 and/or COM2 transfer switch is stuck
in the enabled (or “pressed”) position. Press
the transfer switch again to cycle its operation.
If the problem persists, the system should be
serviced.
COM2 RMT XFR
– COM2 remote
transfer key is stuck.
COM1 CONFIG
– COM1 config
error. Config service req’d.
The COM1 and/or COM2 configuration settings
do not match backup configuration memory.
The system should be serviced.
COM2 CONFIG
– COM2 config
error. Config service req’d.
Zobrazit stránku 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 133 134

Komentáře k této Příručce

Žádné komentáře