Garmin Software Version 0720.13 Uživatelská příručka Strana 116

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 124
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 115
Garmin G1000 Cockpit Reference Guide for the Piper PA-46 Meridian
190-00764-03 Rev. C
Appendix
100
Flight
InstrumentsEICAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
14)
Turn system power ON.
15)
Press the ENT Key to acknowledge the startup screen.
16)
Turn the large FMS Knob to select the AUX Page group on the MFD.
17)
Turn the small FMS Knob to select the System Status Page.
18)
Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
Magnetic Field Variation Database Update
At startup, the system compares this version of the MV DB with that presently being
used by each AHRS (GRS1 and GRS2). If the system determines the MV DB needs to
be updated, a prompt is displayed on the Navigation Map Page, as shown in the figure
below. Note, in the following example, GRS1 is the first AHRS to indicate an update
is available. In actuality, this is dependent on which AHRS is the first to report status
to the system. GRS2 may be displayed before GRS1. The order is not important, only
that both AHRS be updated.
GRS1 Magnetic Field Variation Database Update Prompt
Loading the magnetic field variation database update:
1)
With ‘OK’ highlighted, as shown in the previous figure, press the ENT Key
on the MFD. A progress monitor is displayed as shown in the following
figure.
Zobrazit stránku 115

Komentáře k této Příručce

Žádné komentáře