Garmin Software Version 0369.13 Uživatelská příručka Strana 51

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 184
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 50
Garmin G1000 Cockpit Reference Guide for the DA40/40F
190-00324-07 Rev. A
4-3
SECTION 4 – NAV/COM &
TRANSPONDER
4.1 RADIO STATUS INDICATIONS
RX When a COM signal is received, a white ‘RX’
appears by the active COM frequency during signal
reception.
TX When a COM radio is transmitting, a white ‘TX
indication appears to the right of the corresponding
COM frequency.
ID When the Morse code identifier is ON for a NAV
radio, a
white ‘ID’ indication appears to the left of
the corresponding active NAV frequency. The Morse
code identifier can be heard if the corresponding
NAV radio is selected on the audio panel.
Figure 4-5 Radio Status Indications
4.2 VOLUME
‘VOLUME’ is displayed in place of the associated radio
name (i.e., ‘COM1’ or ‘NAV2’) for two seconds after the
volume level is last changed. The percentage of maximum
volume is displayed in place of the standby frequency
selected by the tuning box.
Figure 4-6 COM Volume Level
4.3 AUTOMATIC SQUELCH
Automatic squelch can be disabled for a COM radio by
pressing the COM Knob to place the tuning box on the
desired COM’s standby frequency, then by pressing the
VOL/PUSH SQ Knob.
4.4 QUICKLY ACTIVATING 121.500 MHZ
Pressing and holding the COM Frequency Transfer
Key for approximately two (2) seconds automatically tunes
the selected COM radio to the emergency frequency.
4.5 OPTIONAL NAV RADIOS
The ADF/DME Tuning Window is displayed by
pressing the ADF/DME Softkey (if no ADF is installed,
the softkey will be labeled DME).
ADF Radio (optional)
Tune the ADF:
1)
From the tuning window, turn the large
FMS
Knob
to highlight the ADF tuning field.
2)
Turn the small
FMS
Knob to enter the first digit.
3)
Turn the large
FMS
Knob to select the next desired
digit field. Turn the small
FMS
Knob to again select
the desired digit.
4)
When the desired frequency is entered press the
ENT
Key to transfer the frequency into the active
field.
5)
Turn the large
FMS
Knob to select the MODE field.
Turn the small
FMS
Knob to select ADF or BFO.
6)
Turn the large
FMS
Knob to select the volume field
if desired. Turn the small
FMS
Knob to adjust the
ADF volume to the desired level.
7)
Press the
FMS
Knob to exit all the fields.
Figure 4-7 ADF/DME Tuning Window
Zobrazit stránku 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 183 184

Komentáře k této Příručce

Žádné komentáře